run a legacy CPL elevated message

Hi,

Hope you can help. I use software called PenPower Jnr 7.1 - it connects a
handwriting pad to a Vista machine. after I ran the calibration module, vista
asks whether the the program opened correctly. I chose "no", now, everytime i
run the calibration, I get prompted to a "Run a legacy CPL elevated" before
it opens
the program and it doesnt work. it doesnt give me an optino to not run in
legacy CPL elevated mode.

how do i run in non legacy CPL elevated mode?

regards,


--
MS SBS 2003 SP2

Hi there, I am sorry but I'm not that technical.

What is CPL and the primary name?

Many thanks,

--
MS SBS 2003 SP2


"WEA" wrote:

> I could find no "one-step" way to resolve this type of situation. I ended up
> doing the following:
>
> 1. Searched to find any prior instances of the cpl and saved them to
> another directory.
>
> 2. Edited the registry looking for the primary name (without the .cpl
> extension). Found several instances but one had a data value (in the
> right-hand pane) of RUNASADMIN.
>
> 3. I clicked on the entry name in the right-hand pane to highlight the line
> and deleted it.
>
> 4. As a precaution, I removed and re-installed the application and
> everything has worked fine since (and I have never seen the message again).
>
> Hope this helps.
>
>
> "Mentos" wrote:
>
> > Hi,
> >
> > Hope you can help. I use software called PenPower Jnr 7.1 - it connects a
> > handwriting pad to a Vista machine. after I ran the calibration module, vista
> > asks whether the the program opened correctly. I chose "no", now, everytime i
> > run the calibration, I get prompted to a "Run a legacy CPL elevated" before
> > it opens
> > the program and it doesnt work. it doesnt give me an optino to not run in
> > legacy CPL elevated mode.
> >
> > how do i run in non legacy CPL elevated mode?
> >
> > regards,
> >
> >
> > --
> > MS SBS 2003 SP2